NEC Xen IPK - Ringing Line Preference Selection

418 – Chapter 1 DRAFT 3 Ringing Line Preference Selection, 4-11
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-11
System Mode
4
Submode
—
Data No.
11
PC Programming
+ BTM
Ringing Line Preference
Selection
General Description
Use this memory block to specify whether or not each station user can answer incoming ringing
CO/PBX calls by going off-hook.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No
Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +AA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R to move to the next Tel Port No.
4
After entering all data, pressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-01 CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
N
1. Programming for this Memory Block applies to Ring Assigned telephones only.
2. An intercom call cannot be originated after a ring assigned CO/PBX line terminates on the telephone.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 1 : R N G P R F Y S
T I M E D I S P L A Y
Data
No.
Title
Tel Port
No.
(01~99)
A0~C0
Setting
Data