NEC Xen IPK - Voice Prompt to Tone Assignment

1-8-16, Voice Prompt to Tone Assignment DRAFT 3 Chapter 1 – 237
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-8-16
System Mode
1
Submode
8
Data No.
16
PC Programming
+ AR
Voice Prompt to Tone
Assignment
General Description
Use this Memory Block to assign the voice prompt to each tone. Voice prompt is provided only
during the Internal Dial tone or Call Waiting tone.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
Voice
Prompt 1
Voice
Prompt 2
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK8 + AFto access the Memory Block.
3
Press corresponding CO/PBX line key to change data option.
Note: Table No. 1: Dial tone
Table No. 2: Call Waiting tone
Default Values
Dial Tone: Voice Prompt 1
Call Waiting Tone: Voice Prompt 2
4
PressNto write the data and advance to Table 02.
5
After entering last data, pressNto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2 Guide to Feature Programming.
1 6 : 0 1 : D T = P R 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Table
No.
Tone
Name