NEC Xen IPK - First to Second Delay Announcement Interval Time Selection

114 – Chapter 1 DRAFT 3 First to Second Delay Announcement Interval Time Selection, 1-1-73
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-73
System Mode
1
Submode
1
Data No.
73
PC Programming
+ AR
First to Second Delay
Announcement Interval
Time Selection
General Description
Use this Memory Block to specify the interval time between the end of the First Delay
Announcement sending time and the start time of the Second Delay Announcement.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0 sec. 10 sec.
20 sec. 30 sec.
LK 5 LK 6 LK 7 LK 8
40 sec. 50 sec. 60 sec. No Limit
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + GC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-74 Second Delay Announcement Repeat Selection
1-1-75 Second Delay Announcement Repeat Interval Time Selection
1-8-13 VRS Message Recording Time Selection
3-43 ACD/UCD Delay Announcement Assignment
N
1. This Memory Block does not display unless the MIFA-U( ) ETU is installed.
2. This Memory Block does not display unless the MIFA-U( ) ETU is installed.
7 3 : M S G I N T V L = 2 0
T I M E D I S P L A Y
Data
No.
Setting
Data
Title