NEC Xen IPK - ISDN BRT Connection Configuration

3-72, ISDN BRT Connection Configuration DRAFT 3 Chapter 1 – 401
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
3-72
System Mode
3
Submode
—
Data No.
72
PC Programming
+ AI
ISDN BRT Connection
Configuration
General Description
Use this Memory Block to specify the type of Basic Rate ISDN Connection configuration
required.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
P-MP P-P
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + GBto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
Rto go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
N
P-MP=Point to Multipoint
P-P=Point to Point
0 1 / 7 2 : C O N N P - M P
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data