NEC Xen IPK - Doorphone Display Time Selection

204 – Chapter 1 DRAFT 3 Doorphone Display Time Selection, 1-7-01
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-7-01
System Mode
1
Submode
7
Data No.
01
PC Programming
+ BTP
Doorphone Display Time
Selection
General Description
Use this Memory Block to define how long a doorphone call signals a station before it times out.
With IPK R2000 and above, this memory block allows flexible entry.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
10 sec. 30 sec. 60 sec. 90 sec.
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK7 + KA to access the Memory Block.
3
Press the CO/PBX line key corresponding to each time assignment. The LED changes to indicate the data each time the
CO/PBX line key is pressed.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK7 + KA to access the Memory Block.
0 1 : D P H T I M E R 1 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
0 1 : D P H T M R 1 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data