3-15, Trunk DTMF Duration/Interdigit Selection DRAFT 3 Chapter 1 – 351
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-15
System Mode
3
Submode
—
Data No.
15
PC Programming
+ BCT
Trunk DTMF Duration/
Interdigit Selection
General Description
Use this Memory Block to specify the tone duration and interdigit time of dual-tone multi-
frequency (DTMF) signals.
Display
Settings
LK 1 LK 2LK 3LK 4
The shaded area indicates
the default setting.
D.D. I.T.
60 ms. 70 ms.
D.D. I.T.
60 ms. 80 ms
D.D. I.T.
110 ms 80 ms
D.D. I.T.
160 ms. 80 ms
LK 5 LK 6 LK 7 LK 8
D.D. I.T.
210 ms 80 ms
D.D. I.T.
410 ms 100 ms
D.D. I.T.
610 ms 100 ms
D.D. I.T.
810 ms 190 ms
Programming Procedures
1
Go off-line.
2
Press LK3 + N + AEto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
R = Next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-92 Trunk (Installed, DP/DTMF) Selection
N
This is also is used for Tie lines.
0 1 / 1 5 : M F 6 0 / 8 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting Data
To Next Page
Loading...
