NEC Xen IPK - ACR Digit Delete Assignment

288 – Chapter 1 DRAFT 3 ACR Digit Delete Assignment, 1-14-05
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-14-05
System Mode
1
Submode
14
Data No.
05
PC Programming
+ AO
ACR Digit Delete Assignment
General Description
Use this Memory Block to specify the number of digits to be deleted from the Route assignment.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK14 + LEto access the Memory Block.
3
Use dial pad keys K~I to select Route No (01~32). and number of digits (00~10).
Note: Use Jto move cursor left.
Use
Lto move cursor right.
If setting data is 00, digits are not deleted.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ACR Feature Allow/Deny Selection
1-14-01 ACR Dialling Assignment
1-14-01 ACR Dialled Number Dial Allow/Deny Selection
1-14-02 ACR Route Table Number Assignment
1-14-05 ACR Digit Add Assignment
1-14-03 ACR Trunk Group to Route Number Assignment
N
The maximum number of digits that can be deleted cannot exceed the number of digits used to route the call.
0 5 : D E L E T E 0 1 = 0 0
T I M E D I S P L A Y
Data
No.
Route
No.
Setting
Data
Title