1-1-09, Manual Pause Selection DRAFT 3 Chapter 1 – 43
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-1-09
System Mode
1
Submode
1
Data No.
09
PC Programming
+ BTS
Manual Pause Selection
General Description
Use this Memory Block to specify either Pause Insertion or Last Number Dialled/Speed Dial to
be executed using the Redial key if it is pressed after one or more digits of a dialled number
are entered.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
No Yes
LK 5LK 6LK 7LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + KI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-00 Hookflash Time Selection
N
1. When a user seizes a CO/PBX line and dials the following sequence without a manual pause (this Memory Block is
set to No),
907 4000 +
Q+ 12345
the system interprets the sequence as:
9074000XXX345 (XXX =
Qand 12 are interpreted as Speed Dial buffer 12).
When a user seizes a CO/PBX line and dials the following sequence with a manual pause (this Memory Block is set
to Yes),
907 4000 +
Q+ 12345
the system interprets the sequence as:
9074000XXX12345 (XXX = is interpreted as a pause).
2. The pause is inserted if Last Number Redial, Save and Repeat, or Store and Repeat is used to redial the number.
3. When this feature is allowed, Multiline Terminal users cannot use consecutive Speed Dial using
Q.
0 9 : M A N P A U S E N O
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
