1-2-19, Intercom Ring Pattern Selection DRAFT 3 Chapter 1 – 137
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-2-19
System Mode
1
Submode
2
Data No.
19
PC Programming
+BI
Intercom Ring Pattern
Selection
General Description
Use this Memory Block to select a ring pattern when intercom calls are made.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Tone Off Tone On Pattern A
Pattern B
LK 5 LK 6 LK 7 LK 8
Pattern C Pattern D Pattern E Pattern F
(Page 2)
LK 1LK 2LK 3LK 4
Pattern G Pattern H
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + L2 + AI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
1 9 : I C M P T N B | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
To Next Page
Loading...
