NEC Xen IPK - Attendant Add-On Console Transfer;Camp-On Recall Timer Selection

1-1-64, Attendant Add-On Console Transfer/Camp-On Recall Timer Selection DRAFT 3 Chapter 1 – 105
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-64
System Mode
1
Submode
1
Data No.
64
PC Programming
+ BM
Attendant Add-On Console
Transfer/Camp-On Recall
Timer Selection
General Description
Use this Memory Block to specify the time interval before a Ring Transfer or Station Camp-On
from a station with an Attendant Add-On Console recalls back to the originating station if the call
is not answered.
This memory block is removed with IPK R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0.5 min.
1 min. 1.5 min. 2 min.
LK 5LK 6LK 7LK 8
3 min. 5 min. 8 min. 10 min.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + FD to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-11 System Transfer/Camp-On Selection
1-1-12 Station Transfer/Camp-On Recall Timer Selection
1-6-00 Attendant Add-On Console to Telephone Port Assignment
1-8-08 Class of Service (Station) Feature Selection 2
N
1. When a station without an assigned Attendant Add-On Console transfers or camps-on a call to a station that goes
unanswered, the call recalls using Memory Block 1-1-12 Station Transfer/Camp-On Recall Timer Selection.
2. Timer is valid only for stations assigned an Attendant Add-On Console in Memory Block 1-6-00 Attendant Add-On
Console to Telephone Port Assignment. The
N key on the station and the console are both affected.
6 4 : D S S R E C L 1 . 0
T I M E D I S P L A Y
Data
No.
Title
1~7
Setting
Data