NEC Xen IPK - CIC Number Assignment

3-70, Hold Tone Automated Attendant Selection DRAFT 3 Chapter 1 – 399
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
3-70
System Mode
3
Submode
—
Data No.
70
PC Programming
+ AW
CIC Number Assignment
General Description
Use this Memory Block to assign the Circuit Identification Code for each voice channel
used for K-CCIS
.
Display
Programming Procedures
1
Go off-line.
2
Press LK3 + N + GK to access the Memory Block.
Note: The following to enter data:
J to go to the next page
L to go to the previous page
K~I to enter numeric data
– OR –
R to go to the next CO/PBX No.
Default Values
000 (Not Specified)
CIC Number Range: 001~127
3
PressNto write the selected data and display next Memory Block or Memory BLock 3-00
CO/PBX 02. After the last CO/PBX is programmed, CO/PBX 01 is displayed again.
Related Programming
M.B. Number Memory Block Name
1-1-05 Start Time Selection
1-15-00 K-CCIS Main/Remote Office selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-04 Destination Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
N
CIC Numbers must be assigned consecutively for K-CCIS to operate correctly.
0 1 / 7 0 : C I C N O 0 0 0
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Setting
Data