NEC Xen IPK - ACR Digit Add Assignment

1-14-06, ACR Digit Add Assignment DRAFT 3 Chapter 1 – 289
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-14-06
System Mode
1
Submode
14
Data No.
06
PC Programming
+ AO
ACR Digit Add Assignment
General Description
Use this Memory Block to specify the number of digits to add to the Route assignment.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK14 + LF to access the Memory Block.
3
Use dial pad keys K~I,J,L to select Route No. (01~32) and enter
the additional dialling digits.
Note: Use Jto move cursor left.
Use
Lto move cursor right.
Use
Q+Jto enter J.
Use
Q+Lto enter L.
Use
Q+Kto enter PAUSE.
Default Values
Not Specified
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ACR Feature Allow/Deny Selection
1-14-01 ACR Dialling Assignment
1-14-01 ACR Dialled Number Dial Allow/Deny Selection
1-14-02 ACR Route Table Number Assignment
1-14-04 ACR Digit Delete Assignment
1-14-03 ACR Trunk Group to Route Number Assignment
N
A maximum of 10 digits can be added to a route assignment.
0 6 / 0 1 =
T I M E D I S P L A Y
Data
No.
Setting
Data
Route
No.