NEC Xen IPK - Line Selection for Automatic Outgoing Calls

1-1-19, Line Selection for Automatic Outgoing Calls DRAFT 3 Chapter 1 – 53
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-19
System Mode
1
Submode
1
Data No.
19
PC Programming
+ BO
Line Selection for Automatic
Outgoing Calls
General Description
Use this Memory Block to specify which trunks will be used when a call is made using the Code
Restriction Password Override Feature.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
NON CO PBX TIE
LK 5LK 6LK 7LK 8
TG 01 RAB 01
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + AI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
TG Setting = Trunk group (01~32)
RAB Setting = Route Advance Block (01~32)
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
1 9 : O G = T G 0 1
T I M E D I S P L A Y
Data
No. Title
Setting
Data