NEC Xen IPK - CO Transfer Ring Pattern Selection

1-1-13, CO Transfer Ring Pattern Selection DRAFT 3 Chapter 1 – 47
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-13
System Mode
1
Submode
1
Data No.
13
PC Programming
+ BCS
CO Transfer Ring Pattern
Selection
General Description
Use this Memory Block to select a Ring Pattern when CO transfers are made.
Display
Settings
(Page 1)
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting
Tone Off Tone On Pattern A Pattern B
LK 5LK 6LK 7LK 8
Pattern C Pattern D Pattern E Pattern F
(Page 2)
LK 1LK 2LK 3LK 4
Pattern G Pattern H
LK 5LK 6LK 7LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + AC to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-11 System Transfer/Camp-On Selection
1-1-14 CO Transfer Ring Tone Selection
1 3 : C O T P T N C | 1
T I M E D I S P L A Y
Data
No. Title
Setting
Data
Page
No.