NEC Xen IPK - Hold Recall Timer Selection (Non Exclusive Hold)

34 – Chapter 1 DRAFT 3 Hold Recall Timer Selection (Non Exclusive Hold), 1-1-03
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-03
System Mode
1
Submode
1
Data No.
03
PC Programming
+ BM
Hold Recall Timer Selection
(Non Exclusive Hold)
General Description
Use this Memory Block to specify the time a Non-Exclusive Hold outside call is held until a recall
tone is generated. If No Limit is selected, the hold recall alarm tone is not generated.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
25 sec. 45 sec.
60 sec. 90 sec.
LK 5 LK 6 LK 7 LK 8
120 sec. 180 sec. 240 sec. No Limit
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 +KCto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
Press N to write the data and display the next Memory Block.
5
Program the next Memory Block or press P to go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 +KCto access the Memory Block.
3
Use the dial pad to enter the time required.
Note:
Jto move cursor left.
Lto move cursor right.
Setting Data (Allow): Class 1 to Class 4: 000 to 255 sec
000 = No Limit
Default values:
Class 1 to Class 4 = 60 secs
0 3 : H O L D R E C L 6 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
0 3 : H L D R C L X = 0 6 0 s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Class