4-29, HFU Selection DRAFT 3 Chapter 1 – 435
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
4-29
System Mode
4
Submode
—
Data No.
29
PC Programming
+ BTM
HFU Selection
General Description
Use this memory block to enable/disable (per station) the built-in Handsfree operation of Multiline
terminals.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
No Ys
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +BI to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 2 9 : H F U N O
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Setting
Data
Table
To Next Page
Loading...
