NEC Xen IPK - Destination Point Code Assignment

1-15-04, Destination Point Code Assignment DRAFT 3 Chapter 1 – 297
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-15-04
System Mode
1
Submode
15
Data No.
04
PC Programming
+ AW
Destination Point Code
Assignment
General Description
Use this Memory Block to assign the Destination Point Code for each Common Signalling
Channel
.
Applicable for IPK R2000 and above.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK15 + KD to access the Memory Block.
3
Use dial pad keys to enter Setting Data.
Note: Use the following pad keys to enter Setting Data:
Jto move cursor left.
Lto move cursor right.
K~Ito enter numeric data.
Note: Point Code Range is 00001~16367
Default Values
:
Blank
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
7-3-01 MIF (LCR) Assignment
7-3-02 MIF (SMDR) Assignment
1-15-00 K-CCIS Main/Remote Office Selection
1-15-02 Common Signal Channel Assignment
1-15-03 Originating Point Code Assignment
1-15-05 Destination Point Code Transfer Assignment
1-15-06 Originating Office Code Number Assignment
1-15-07 K-CCIS Message Response Timeout Assignment
1-15-08 Link Reconnect Allow/Deny Selection
1-15-09 K-CCIS Maximum Call Forwarding Hop Assignment
1-15-10 Calling Name Display Allow/Deny Selection
0 4 : D S T C C H 1
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
C-Channel
1~4