NEC Xen IPK - SIE;CAR Ringing Line Preference Selection

4-41, SIE/CAR Ringing Line Preference Selection DRAFT 3 Chapter 1 – 447
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-41
System Mode
4
Submode
—
Data No.
41
PC Programming
+ BTM
SIE/CAR Ringing Line
Preference Selection
General Description
Use this Memory Block to specify whether to allow/deny Ringing Line Preference (go off-hook or
press Speaker key) on all telephones that are assigned Secondary Incoming Extension (SIE)
and/or Call Arrival keys.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No
Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +DA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to change option:
R select next Tel Port No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-37 Extension Line Key Ring Assignment (Day Mode)
4-38 Extension Line Key Ring Assignment (Night Mode)
N
1. Telephone ports A0~C0 are ports 100~120.
2. The SIE/CAR must be ringing for this Memory Block to work.
0 1 / 4 1 : S - C P R F Y S
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data