NEC Xen IPK - Doorphone Assignment

1-7-00, Doorphone Assignment DRAFT 3 Chapter 1 – 203
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-7-00
System Mode
1
Submode
7
Data No.
00
PC Programming
+ BTP
Doorphone Assignment
General Description
Use this Memory Block to enable the doorphones in System Programming.
Display
Settings
LK 1LK 2LK 3LK 4
There is no
default setting.
DP1 DP2 DP3 DP4
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK7 + KK to access the Memory Block.
3
Press the CO/PBX line key corresponding to each doorphone. The LED changes to indicate the data each time the CO/PBX
line key is pressed.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-01 Doorphone Display Time Selection
0 0 : D P H A S S I G N
T I M E D I S P L A Y
Data
No.
Title
CO/PBX
Line LED
Off On
Data No Yes
There is no default
setting.