NEC Xen IPK - MIF (Caller ID) Assignment

512 – Chapter 1 DRAFT 3 MIF (Caller ID) Assignment, 7-3-04
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
7-3-04
System Mode
7
MIF
3
Data No.
04
PC Programming
+ BS
MIF (Caller ID) Assignment
General Description
Use this Memory Block to enable the Caller ID scrolling or outdial function on the MIFM-U( )
ETU. Basic Caller ID works without an MIFM-U( ) ETU installed.
Display
Programming Procedures
1
Go off-line.
2
Press LK7 + LK3 + J + J +KD to access the Memory Block.
3
Use the dial pad to enter data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Setting Data 00, 01, 02
Default Values
No Function (00)
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
Caller ID scrolling and outdial must have the KMM(XXX)U installed on the MIFM-U( ) ETU.
0 4 : C L A S S M I F = 0 0
T I M E D I S P L A Y
Data
No.
Title
Setting
Data