1-1-21, DID Digit Conversion Assignment DRAFT 3 Chapter 1 – 55
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-1-21
System Mode
1
Submode
1
Data No.
21
PC Programming
+ ALN
DID Digit Conversion
Assignment
General Description
Use this Memory Block to enable the DID Digit Conversion Table & DNIS Assignment, Memory
Block 1-1-22, for each number. If No is assigned here, only Memory Block 5-00 has an impact on
incoming DID numbers. If Yes is assigned here, incoming DID numbers can be modified
completely for each number.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No Yes
LK 5
LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + BA to access the Memory Block.
3 Enter the data using the Line key. Default Values
NO
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-1-20 DID Digit Length Selection
1-1-22 DID Digit Conversion Table & DNIS Assignment
1-1-23 DID Forward Station Number for Busy Station or Undefined Digit
2 1 : D I D C N V Y S
T I M E D I S P L A Y
Data
No. Title
Setting
Data
To Next Page
Loading...
