96 – Chapter 1 DRAFT 3 CO/PBX Prepause Timer Selection, 1-1-57
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-1-57
System Mode
1
Submode
1
Data No.
57
PC Programming
+ BCM
CO/PBX Prepause Timer
Selection
General Description
Use this Memory Block to assign a pause time before dialled digits can be sent over a CO/PBX
line after the trunk is seized by a system user.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
None 1 sec. 2 sec.
3 sec.
LK 5 LK 6 LK 7 LK 8
4 sec. 5 sec. 6 sec. 7 sec.
(Page 2)
LK 1 LK 2 LK 3 LK 4
8 sec. 9 sec. 10 sec. 11 sec.
LK 5 LK 6 LK 7 LK 8
12 sec. 13 sec.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + EG to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to change page:
S to move to next page
T to move to previous page
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
5 7 : P R E P A U S E 3 s | 1
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Page
No.
To Next Page
Loading...
