NEC Xen IPK - Digit Matching Table to OCC Table Assignment

1-1-68, 8-Digit Matching Table to OCC Table Assignment DRAFT 3 Chapter 1 – 109
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-1-68
System Mode
1
Submode
1
Data No.
68
PC Programming
+ AC
8-Digit Matching Table to
OCC Table Assignment
General Description
Use this Memory Block to assign each 8-Digit Matching Table to each Other Common Carrier
(OCC) Code Table.
Display
Settings
(Page 1) (Page 2)
LK 1 LK 2 LK 3 LK 4 LK 1 LK 2 LK 3 LK 4
There is no
default setting.
Table 00 Table 01 Table 02 Table 03 Table 08 Table 09 Table 10 Table11
LK 5 LK 6 LK 7 LK 8 LK 5 LK 6 LK 7 LK 8
Table 04 Table 05 Table 06 Table 07 Table 12 Table13 Table14 Table15
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + FH to access the Memory Block.
3
Press the corresponding CO/PBX line key to change data option.
Note: Use the following to enter data:
Sto access the next page
Tto access the previous page.
Each time a CO/PBX line key is pressed, the LED toggles between On
and Off.
Default Values
OCC Tables 01~15:
All Matching Tables Not Used
OCC Table 16:
Matching Tables 00~14 Not Used
Matching Table 15 Used
4
PressNto write the data and advance to the next OCC table. Repeat steps 3 and 4 until last OCC data is assigned.
5
PressNto write the last data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Section 6 Code Restriction in this chapter.
6 8 : 8 D G O C C ( 0 1 ) | 1
T I M E D I S P L A Y
Data
No.
OCC
Table
01~16
Title
Function No.
CO/PBX
Line LED
Off On
Data Unused Used
There is no default setting.