3-22, Tie Line Length of Delay Signal Selection DRAFT 3 Chapter 1 – 361
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-22
System Mode
3
Submode
—
Data No.
22
PC Programming
+ ALM
Tie Line Length of Delay
Signal Selection
General Description
Use this Memory Block to specify the time a delay pulse is sent to another system.
Display
Settings
(Page 1)
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0 ms.
300 ms. 600 ms. 900 ms.
LK 5 LK 6 LK 7 LK 8
1200 ms. 1500 ms. 1800 ms. 2100 ms.
(Page 2)
LK 1LK 2LK 3LK 4
2400 ms. 2700 ms. 3000 ms. 3300 ms.
LK 5 LK 6 LK 7 LK 8
3600 ms. 3900 ms. 4200 ms. 4500 ms.
Programming Procedures
1
Go off-line.
2
Press LK3 + N + BB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
S to go to the next page
T to go to the previous page
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
0 1 / 2 2 : D E L Y 3 0 0 | 1
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
Page
No.
Setting
Data
Delay Pulse Sending
Receiving Side
Receiving Signal Detection
Time
DC Loop Supervision
To Next Page
Loading...
