NEC Xen IPK - PRT B Channel-To-Trunk Group Assignment

278 – Chapter 1 DRAFT 3 PRT B Channel-to-Trunk Group Assignment, 1-13-05
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-13-05
System Mode
1
Submode
13
Data No.
05
PC Programming
+ AN
PRT B Channel-to-Trunk
Group Assignment
General Description
Use this Memory Block to assign a Trunk Group Number to each B channel or any Trunk
Group for each B channel. Changing this assignment is not normally required and default
should be set. This Memory Block could be used when different trunks are used in the same
PRI span or for a tenant application where multiple tenants share the PRI span and
separation of B channels is required
.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK13 + KE to access the Memory Block.
3
Use the following to enter data:
Jto move the cursor left.
Lto move the cursor right.
K~Ito enter numeric data. (00~30, 00=Not Assigned)
00 is Any Trunk Group
01~32 are Trunk Groups 01~32
Default Values
00, Any Trunk Group
4
PressNto write the data and display the next B channel or next Memory Block.
5
Program the next Memory Block or pressPTo go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
1-13-00 PRI Channel Assignment
1-13-04 PRT B Channel Outgoing Priority Selection
3-03 Trunk-to-Trunk Group Assignment
3-91 Trunk Type Selection
N
1. This Memory Block must be coordinated with Memory Block 3-03 (Trunk-to-Trunk Group Assignment). The number of
assigned channels must be the same or greater (including default) than the number of trunks to a trunk group
assigned In Memory Block 3-03.
For Example, When Memory Block 3-03 has five PRT trunks for Trunk Group 1, this Memory Block must have at least
five B channels for Trunk Group 1.
2. This Memory Block applies only to PRT(1)-U( ) ETU firmware version 4.0 or higher.
Display
0 1 / 0 5 : B 0 1 = T G 0 0
T I M E D I S P L A Y
PRT
No.
Data
No.
Title
Setting
Data CO
Setting
Data B-