NEC Xen IPK - ACR Trunk Group to Route Number Assignment

1-14-04, ACR Trunk Group to Route Number Assignment DRAFT 3 Chapter 1 – 287
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-14-04
System Mode
1
Submode
14
Data No.
04
PC Programming
+ AB
ACR Trunk Group to Route
Number Assignment
General Description
Use this Memory Block to specify whether a Trunk Group is used for each Route assignment.
Display
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded selection
is the default.
NORMAL
(Originate)
TKGP
(01~32)
RAB
(01~32)
ICM
Programming Procedures
1
Go off-line.
2
Press LK1 + LK14 + LDto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data 1 option.
Use dial pad keys
K~I to select Data Setting Data 2 Trunk Group Number (01~32) or Setting Data 2 RAB (1~16).
Note: Press Jto move cursor left.
Press
Lto move cursor right.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ACR Feature Allow/Deny Selection
1-14-01 ACR Dialling Assignment
1-14-02 ACR Dialled Number Dial Allow/Deny Selection
1-14-03 ACR Route Table Number Assignment
1-14-05 ACR Digit Delete Assignment
1-14-06 ACR Digit Add Assignment
N
If NORMAL is selected, the call is routed to Trunk Group 1 exactly as dialled.
0 4 / 0 1 = N O R M A L
T I M E D I S P L A Y
Data
No.
Setting
Data 1
Route
No.
Setting
Data 2