NEC Xen IPK - Line Key Selection for Telephone Mode

4-12, Line Key Selection for Telephone Mode DRAFT 3 Chapter 1 – 419
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-12
System Mode
4
Submode
—
Data No.
12
PC Programming
+ BTM
Line Key Selection for
Telephone Mode
General Description
Use this Memory Block to assign functions to each CO/PBX line key on each telephone in a
tenant specified as Telephone Mode in Memory Block , 2-05 , Line Key Selection.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Not Specified
CO/PBX Line CFW-B/NA CFW-ALL
LK 5 LK 6 LK 7 LK 8
Call
Appearance
Feature
Access
Trunk Group
Route
Advance
LK 9 LK 10 LK 11 LK 12
SIE/CAR
Microphone
Key
Headset
Scroll Key for
Caller ID
LK 13 LK 14 LK 15 LK 16
DND
On/Off
LOG
On/Off
BGM
On/Off
ICM
Programming Procedures
1
Go off-line.
2
Press LK4 + ABto access the Memory Block.
3
Press corresponding CO/PBX line key to change setting data 1.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K ~ I to enter setting data 2
R to move to the next Tel Port No
For example, to assign Trunk Group 5 to CO/PBX line key 1, press LK7 to
display TKGP, and enter 05 (for RT 05) using the dial pad.
Default Values
For Tel 01~CO: LK01~08 Assigned to
CO/PBX lines 01~08.
4
PressNto write the data and display the next line key.
5
Repeat example and step 4 until all line key assignments are complete, and press Nto enter last data.
6
PressPto go back on-line.
0 1 / 1 2 : L 0 1 = C O 0 1
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data 2
Setting
Data 1
Line Key No.
(01~24)