3-39, Automatic Release Selection DRAFT 3 Chapter 1 – 379
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-39
System Mode
3
Submode
—
Data No.
39
PC Programming
+ AU
Automatic Release Selection
General Description
This Memory Block specifies whether or not the system is to release a trunk used to make an
outgoing call when the called party hangs. Selecting Yes will result in the system disconnecting
the trunk upon the outside party hanging up. Selecting No will result in the trunk being held upon
the outside party hanging up, the trunk only being released when the KTS extension hangs up.
Display
Settings
LK1 LK2 LK3 LK4
The shaded area indicates
the default setting.
No
Yes
LK5 LK5 LK7 LK8
Programming Procedures
1
Go off-line.
2
Press LK3 +N+ CIto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
The attendant telephone position must dial an Access Code to activate this feature.
0 1 / 3 9 : A U T O R L S = Y S
T I M E D I S P L A Y
Data
No.
Setting
Data
CO/PBX
No.
(01~64)
Title
To Next Page
Loading...
