NEC Xen IPK - ACR Feature Allow;Deny Selection

1-14-00, ACR Feature Allow/Deny Selection DRAFT 3 Chapter 1 – 281
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-14-00
System Mode
1
Submode
14
Data No.
00
PC Programming
+ AO
ACR Feature Allow/Deny
Selection
General Description
Use this Memory Block to specify whether or not ACR is system wide.
*When ACR is set to Allow in this MB, LCR stored on the MIF-L will stop functioning.
Display
Settings
LK 1LK 2LK 3LK 4
The shaded selection
is the default.
NO
(Deny)
YES
(Allow)
LK 5LK 6LK 7LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK14 to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the Setting Data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-8-08 Class of Service (Station) Feature Selection 2
1-14-01 ACR Dialling Assignment
1-14-01 ACR Dialled Number Dial Allow/Deny Selection
1-14-03 ACR Trunk Group to Route Number Assignment
1-14-05 ACR Digit Add Assignment
1-14-02 ACR Route Table Number Assignment
1-14-04 ACR Digit Delete Assignment
0 0 : A C R N O
T I M E D I S P L A Y
Data
No.
Title
Setting
Data