NEC Xen IPK - Intercom Call Voice;Tone Signal Selection

1-2-01, Intercom Call Voice/Tone Signal Selection DRAFT 3 Chapter 1 – 129
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-2-01
System Mode
1
Submode
2
Data No.
01
PC Programming
+BI
Intercom Call Voice/Tone
Signal Selection
General Description
Use this Memory Block to determine whether signal tone or voice is used first for an
intercom call.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Tone
Voice
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 +KAto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-6-03 DSS Call Voice/Tone Signal Selection
N
1. Switch from voice to tone signalling or from tone to voice by dialling a station number, then dialling 1.
2. If tone signalling is programmed in this Memory Block, the called party cannot answer handsfree unless the originator
of the call dials 1.
3. This Memory Block has no effect on incoming Voice Announcement Tie/DID line calls. Refer to Memory Block , 1-1-34
, Tie Line First Ring Pattern Selection.
0 1 : T O N E C A L L
T I M E D I S P L A Y
Data
No.
Title
Setting
Data