NEC Xen IPK - Extension Line Key Ring Assignment (Day Mode)

4-37, Extension Line Key Ring Assignment (Day Mode) DRAFT 3 Chapter 1 – 441
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-37
System Mode
4
Submode
—
Data No.
37
PC Programming
+ BTM
4-37
System Mode
4
Submode
—
Data No.
37
PC Programming
+ BTM
Extension Line Key Ring
Assignment (Day Mode)
General Description
Use this Memory Block to specify the ringing assignment on incoming calls to a Secondary
Incoming Extension (SIE) or a Call Arrival key.
Display
Settings
Page 1 (Line Keys 01~08)
LK 1LK 2LK 3LK 4
There is no
default setting.
1234
LK 5 LK 6 LK 7 LK 8
5678
Page 2 (Line Keys 09~16)
LK 1LK 2LK 3LK 4
9101112
LK 5 LK 6 LK 7 LK 8
13 14 15 16
Page 3 (Line Keys 17~24)
LK 1LK 2LK 3LK 4
17 18 19 20
LK 5 LK 6 LK 7 LK 8
21 22 23 24
Programming Procedures
1
Go off-line.
2
Press LK4 + CG to access the Memory Block.
3
Use the dial pad to select option.
The LED indication changes to indicate data each time a CO/PBX line key is
pressed.
Note: Use the following to enter data:
S go to next page
T go to previous page
Rto select next Tel Port No.
Default Values
All Telephones: No Ring
4
PressNto write the data.
5
PressPto go back on-line.
0 1 / 3 7 : E X T D A Y | 0 1
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Page
CO/PBX
Line Key LED
Off Green Red
Data
No ring
Immediat
e Ring
Delayed
Ring