1-7-09, External Speaker Chime Start Time Selection DRAFT 3 Chapter 1 – 215
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-7-09
System Mode
1
Submode
7
Data No.
09
PC Programming
+ BP
External Speaker Chime Start
Time Selection
General Description
This Memory Block is used only when paging alert tone (4-tones) is assigned in Memory Block 1-
7-08 (External Speaker Chime Selection). This Memory Block assigns the delay after an external
paging code is dialled and before the paging alert tone is provided.
Display
(Page 1)
LK 1LK 2LK 3LK 4
The shaded area indicates
the default setting.
0 ms. 100 ms. 200 ms. 300 ms.
LK 5LK 6LK 7
LK 8
400 ms. 500 ms. 600 ms.
700 ms.
(Page 2)
LK 1LK 2LK 3LK 4
800 ms. 900 ms. 1000 ms. 1100 ms.
LK 5 LK 6 LK 7 LK 8
1200 ms. 1300 ms. 1400 ms. 1500 ms.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK7 +KIto access the Memory Block.
3 Press the corresponding CO/PBX line key to change the data option.
Note: Use the following when entering data:
Sto go to the next page
T to go to the previous page
4
PressNto write the data and advance to Memory Block 1-8-01 SLT or Automated Attendant/DISA to PBR Selection.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-7-08 External Speaker Chime Selection
0 9 : S T A R T = 7 0 0 m s
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
To Next Page
Loading...
