NEC Xen IPK - Trunk-To-Trunk Transfer Yes;No Selection

342 – Chapter 1 DRAFT 3 Trunk-to-Trunk Transfer Yes/No Selection, 3-04
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
3-04
System Mode
3
Submode
—
Data No.
04
PC Programming
+ BCT
Trunk-to-Trunk Transfer Yes/
No Selection
General Description
This Memory Block specifies whether or not to allow Trunk-to-Trunk Transfer.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
No
Yes
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + KDto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-07 Class of Service (Attendant) Feature Selection 1
1-8-08 Class of Service (Station) Feature Selection 2
3-05 Trunk Incoming Answer Mode Selection
3-06 Automatic Tandem Trunk Assignment
5-01 Tie Line Networking Tandem Connection Assignment
N
Assign Yes to connect both trunks via Trunk-to-Trunk Transfer or Automatic Trunk-to-Trunk Transfer feature.
0 1 / 0 4 : T R F Y S
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Setting
Data
Title