3-11, CO External Source Selection DRAFT 3 Chapter 1 – 347
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
3-11
System Mode
3
Submode
—
Data No.
11
PC Programming
+ BCT
CO External Source Selection
General Description
Use this Memory Block to specify which CO Trunk is to have an External Music Source
connected. A powered LIU must be used for Music Source Input. (Refer to the System Hardware
Manual for details).
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
CO
Ext Source
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK3 + N + AAto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following when entering data:
R to go to the next CO/PBX Line No.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-12 CO Hold Melody Selection (CO)
N
1. This is also used for Tie lines.
2. When CO is set for EXT SOURCE and left in a trunk group, that CO is skipped in dialling access of the trunk group.
1 1 / 1 1 : C O
T I M E D I S P L A Y
CO/PBX
No.
(01~64)
Data
No.
Title
To Next Page
Loading...
