NEC Xen IPK - Voice Mail DTMF Delay Timer Selection

1-3-08, Voice Mail DTMF Delay Timer Selection DRAFT 3 Chapter 1 – 161
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-3-08
System Mode
1
Submode
3
Data No.
08
PC Programming
+ AV
Voice Mail DTMF Delay
Timer Selection
General Description
Use this Memory Block to specify the delay time before dual-tone multifrequency (DTMF) tones
are sent from Voice Mail Interface (VMI) ports.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
0 sec.
1 sec. 2 sec. 3 sec.
LK 5 LK 6 LK 7 LK 8
4 sec. 5 sec. 6 sec. 8 sec.
Programming Procedures
1
Go off-line.
2
Press LK1 + LK3 +KHto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-35 Voice Mail/SLT Selection
N
This Memory Block applies to both digital voice mail and analogue voice mail ports.
0 8 : V M D E L A Y = 1 S
T I M E D I S P L A Y
Setting
Data
Title
Data
No.