NEC Xen IPK - CO Line Mode Copy Assignment

6-3, CO Line Mode Copy Assignment DRAFT 3 Chapter 1 – 495
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
6-3
System Mode
6
Submode
3
Data No.
—
CO Line Mode Copy
Assignment
General Description
Use this Memory Block to enable copying data from one CO/PBX line to another CO/PBX line or
multiple consecutive CO/PBX lines.
Example: To copy data of CO/PBX line 01 to CO/PBX line 05~07:
1. Enter the original CO/PBX No. Using the dial pad, press
KA.
2. Press
N.
Display
Programming Procedures
1
Go off-line.
2
Press LK6 + LK3 to access the Memory Block.
3
Enter the CO/PBX line to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
C O — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
C O 0 1 — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
C O —
T I M E D I S P L A Y
Title
Setting
Data