NEC Xen IPK - Intercom Feature Access Code Assignment

146 – Chapter 1 DRAFT 3 Intercom Feature Access Code Assignment, 1-2-24
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-2-24
System Mode
1
Submode
2
Data No.
24
PC Programming
+BA
Intercom Feature Access
Code Assignment
General Description
Use this Memory Block to assign the Access Code for Voice/Tone change or Step Call.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + BD to access the Memory Block.
3
Use the dial pad to enter the Setting Data.
Note: Use the following to enter data:
Jto move the cursor left
Lto move the cursor right
K~Ito enter numeric data
Default Values
4
PressNto write the data and advance to the next Dial No.
5
After entering all data, press Nto write the data.
6
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-2-01 Intercom Call Voice/Tone Signal Selection
1-8-08 Class of Service (Station) Feature Selection 2
1-8-26 Voice Mail Quick Transfer Master Hunt Number
4-17 Station to Class of Service Feature Assignment
2 4 : F E A A C ( 0 ) = 0 0 4
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Setting Data
Setting Code Feature
000 Not Used
001 Voice/Tone Switching
002 Step Call
003 Tone Override
004 Automatic Callback
005 Callback Request
006 Voice Over Originate
007 Quick Transfer to Voice Mail
Dial Numbers
0 = 004
1 = 001
2 = 002
3~5 = 000
6 = 006
7 = 007
8,9 = 000
 = 003
# = 005