Section 1, General Information DRAFT 3 Chapter 3 – 599
Doc. No.: 8194 - Release 2.0
December 2004
PC Programming Chapter 3
SECTION 1
GENERAL
INFORMATION
This chapter provides detailed information for programming using the Xen
Maintenance Access Terminal (MAT) software.
PC requirements:
Microsoft Windows 95 operating system
Available serial communication port on PC
MNP Class 4 or V.42 bis modem (if remote programming is required)
KTS hardware requirements:
MIFM-U( ) KTU
IMPORTANT
A second initialisation is recommended after a normal upload. System with
VMS, FMS, ACD and/or IPT cards installed, please ensure all cards had
completed their startup sequence before performing a second initialisation.
These cards are considered fully ‘started up’ about 5 minutes after power
is applied.
SECTION 2
FEATURES OF PC
PROGRAMMING
Some of the features of PC programming include:
Wizard Allows a user to select a feature using Wizard. Wizard
prompts the user to program the necessary system data
items associated with the feature. When Wizard is
selected, a tabbed list of information is provided.
(For a detailed discussion of Wizard, refer to
Section 4 Wizard on page 600.)
System Data Upload/
Download
Allows system data to be transferred from/to a personal
computer to provide backup of data.
To Next Page
Loading...
