262 – Chapter 1 DRAFT 3 Clear Channel Selection, 1-11-01
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0
December 2004
1-11-01
System Mode
1
Submode
11
Data No.
01
PC Programming
+ AD
Clear Channel Selection
General Description
Use this Memory Block to specify the clear channel selection. when the Zero Byte Time
channel is available, the CLKG-U( ) Unit cannot extract a clock signal from the T1
trunk. The T1 trunk modifies the Zero Byte Time channel to extract a clock signal for the
CLKG-U( ) Unit
.
Applicable for R2000 and above.
Display
Settings
LK1 LK2 LK3 LK4 LK5 LK6 LK7 LK8
The shaded area indicates
the default setting.
ZCS B8ZS
Programming Procedures
1
Go off-line.
2
Press LK1 + LK11 + KA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data. The next Memory Block is displayed.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
N
The DTI-U( ) ETU must be assigned in the system to set this Memory Block.
0 1 / 0 1 : O B Y T E = Z C S
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
DTI No.
(01~08)
To Next Page
Loading...
