NEC Xen IPK - Station to Call Appearance Block Assignment

4-43, Station to Call Appearance Block Assignment DRAFT 3 Chapter 1 – 449
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-43
System Mode
4
Submode
—
Data No.
43
PC Programming
+ BTT
Station to Call Appearance
Block Assignment
General Description
Use this Memory Block to assign a Multiline Terminal to a Call Appearance Block.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 + DC to access the Memory Block.
3
Use the dial pad to enter Call Appearance Block (00 ~ 47).
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to select next Tel Port No.
Default Values
All stations are assigned to
Call Appearance Block 00.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
Refer to Chapter 2, Guide to Feature Programming.
N
Telephone ports A0~C0 are ports 100~120.
0 1 / 4 3 : C A P N O 0 0
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data