2-05, Line Key Selection DRAFT 3 Chapter 1 – 331
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
2-05
System Mode
2
Submode
—
Data No.
05
PC Programming
+ BN
Line Key Selection
General Description
Use this Memory Block to allow the technician to specify either of two line key assignment modes
for each tenant. The choices are Tenant-Wide Mode or Telephone Mode.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
Tenant-
Wide
Mode
Telephone
Mode
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK2 +KEto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-06 Line Key Selection for Tenant Mode
4-12 Line Key Selection for Telephone Mode
N
1. Mixed use of Tenant-Wide Mode and Telephone Mode in the system is permitted.
2. Tenant-Wide Mode:
Memory Block 2-06 Line Key Selection for Tenant Mode permits assignment of any desired feature to each of the
CO/PBX line keys. All the telephones in a tenant are assigned the same features.
3. Telephone Mode:
Memory Block 4-12 Line Key Selection for Telephone Mode permits assignment of any feature to each of the CO/
PBX line keys. Each telephone can be assigned different features.
0 0 / 0 5 : M O D E T E L
T I M E D I S P L A Y
Data
No.
Setting
Data
Tenant
No.
(00~47)
Title
To Next Page
Loading...
