NEC Xen IPK - Page 350

December 2004 NEC Business Solutions Ltd
330 – Chapter 1 DRAFT 3 Trunk to Tenant Assignment, 2-01
Doc. No.: 8194 - Release 2.0 December 2004
Programming Procedures
1
Go off-line.
2
Press LK2 + KAto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
Rto go to the next Tenant No.
S to go to the next page
T to go to the previous page
Default Values
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
2-05 Line Key Selection
4-09 Telephone to Tenant Assignment
N
If data is changed while the system is busy, DATA ENTRY is displayed at the programming station until the system
becomes idle.
CO/PBX
Line LED
Off Off
Data
No
(Not Assigned)
Yes
(Assigned)
There is no
default setting.
Tenant
00
Tenant
01~47
CO/PBX lines 01~64
assigned (YES)
Not
assigned