NEC Xen IPK - CO;PBX Answer Key Operation Without Ringing Assignment (Day Mode)

458 – Chapter 1 DRAFT 3 CO/PBX Answer Key Operation without Ringing Assignment (Day Mode), 4-52
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
4-52
System Mode
4
Submode
—
Data No.
52
PC Programming
+ BTT
CO/PBX Answer Key
Operation without Ringing
Assignment (Day Mode)
General Description
This Memory Block is used to disable Ring Assigned telephones from ringing during Day and
allowing Message Waiting and Answer Key to blink, therefore allowing calls to be answered.
Display
Settings
LK 1 LK 2 LK 3 LK 4
The shaded area indicates
the default setting.
NO
YS
LK 5 LK 6 LK 7 LK 8
Programming Procedures
1
Go off-line.
2
Press LK4 +EB to access the Memory Block.
3
Press the corresponding CO/PBX line key to change language option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
4-01 CO/PBX Ring Assignment (Day Mode)
4-02 CO/PBX Ring Assignment (Night Mode)
N
1. Telephone ports A0~C0 are ports 100~120.
2. Setting to YES - the telephone will ring for all Ring Assigned lines set in Memory Blocks , 4-01 and , 4-02.
3. Setting to NO - the telephone will not ring for any Ring Assigned lines however the Message Waiting Lamp and
Answer Key will flash. When NO is selected neither Caller ID nor Trunk Name Assignment will be displayed.
0 1 / 5 2 : R I N G D N O
T I M E D I S P L A Y
Data
No.
Tel Port No.
(01~99)
A0~C0
Title
Setting
Data