NEC Xen IPK - PRI Channel Assignment

1-13-00, PRI Channel Assignment DRAFT 3 Chapter 1 – 275
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
1-13-00
System Mode
1
Submode
13
Data No.
00
PC Programming
+ AN
PRI Channel Assignment
General Description
This Memory Block specifies the number of channels available on each PRI ISDN line connected
to the system via a PRT(1)-U( ) ETU.
Display
Settings
Page 1
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
The shaded area
indicates the
default setting.
Channel 1 Channel 2 Channel 3 Channel 4 Channel 5 Channel 6 Channel 7 Channel 8
Page 2
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Channel 9 Channel 10 Channel 11 Channel 12 Channel 13 Channel 14 Channel 15 Channel 16
Page 3
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Channel 17 Channel 18 Channel 19 Channel 20 Channel 21 Channel 22 Channel 23 Channel 24
Page 4
LK 1 LK 2 LK 3 LK 4 LK 5 LK 6 LK 7 LK 8
Channel 25 Channel 26 Channel 27 Channel 28 Channel 29 Channel 30
CO/PBX
Line LED
Off
On
The shaded selection
is the default
Data
No (Not
Assigned)
Yes
(Assigned)
Programming Procedures
1
Go off-line.
2
Press LK1+ LK13 +KKto access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
7-1 Card Interface Slot Assignment
3-92 Trunk (Installed, DP/DTMF) Selection
1-8-33 Master Clock Selection
3-57 ISDN Dial-Out Sending Selection
0 1 / 0 0 : C H A N E L 0 1
T I M E D I S P L A Y
PRT
(1-8
Title
Setting
Data
Data
No.