NEC Xen IPK - CO;PBX Busy Forward Station Assignment

4-13, CO/PBX Busy Forward Station Assignment DRAFT 3 Chapter 1 – 421
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
4-13
System Mode
4
Submode
—
Data No.
13
PC Programming
+ BTT
CO/PBX Busy Forward
Station Assignment
General Description
Use this Memory Block to specify up to two telephones to ring when a CO/PBX call terminates at
a busy station.
Display
Programming Procedures
1
Go off-line.
2
Press LK4 + ACto access the Memory Block.
3
Use dial pad to change data.
Note: Use the following to enter data:
J to move the cursor left
L to move the cursor right
K~I to enter numeric data
R to move to the next Tel Port No
Setting Data: Port No. 01 ~120
Default Values
Not specified
4
PressNto write the data for the first transfer to station.
5
Enter second transfer to station.
6
PressNto write the data.
7
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. If the Multiline Terminal where the forward is initially set (Forward 1) is busy, the call is forwarded to a second
specified station (Forward 2).
2. If all three stations are busy, the first station rings.
3. Telephone ports A0~C0 are ports 100~120.
0 1 / 1 3 : F W D 1 =
T I M E D I S P L A Y
Data
No.
Tel Port
No.
(01~99)
A0~C0
Setting
Data
Title
Forward
No. 1/2