NEC Xen IPK - ISDN Dial Interval Timer

122 – Chapter 1 DRAFT 3 ISDN Dial Interval Timer, 1-1-81
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-81
Submode
1
Submode
1
Data No.
81
PC Programming
+ AN
ISDN Dial Interval Timer
General Description
Use this Memory Block to specify the Dial Interval Timer for ISDN lines.
With IPK R2000 and above, this memory block allows flexible entries and has four classes.
For R2000 only.
For R2000 and above.
Display
Settings
LK 1 LK 2LK 3LK 4
The shaded area indicates
the default settings.
2s
4s 8s 16s
LK 5LK 6LK 7LK 8
32s
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + HA to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data.
5
PressPto go back on-line.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + HA to access the Memory Block.
3
Use the dial pad to enter the time required.
Note:
Jto move cursor left.
Lto move cursor right.
Setting Data (Allow): 01 to 99 sec
Default values: 4 sec
8 1 : I S D N D I A L 8 s
T I M E D I S P L A Y
Data
No.
Setting
Data
Title
8 1 : I S D N D I A L 0 4 s
T I M E D I S P L A Y
Data
No.
Setting
Data
Title