1-2-30, PS Out of Area Timer Selection (BSU only) DRAFT 3 Chapter 1 – 151
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0
December 2004
1-2-30
System Mode
1
Submode
2
Data No.
30
PC Programming
+AP
PS Out of Area Timer
Selection (BSU only)
General Description
Use this Memory Block to specify the retry time when a Dterm PS is Out of Area.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK2 + CK to access the Memory Block.
3
Use the Dial Pad to enter the setting data
Note: Use the following to enter data:
Jto move the cursor left
Lto move the cursor right
Default Values
12 sec
Setting Data
00~99
4
PressNto write data.
5
PressPto go back on-line.
Related Programming
No related programming is necessary for this Memory Block.
N
1. Ring Back Tone is the ringing tone heard by the caller.
2. Refer to the Features and Specifications manual, feature M6 - Multi-zone Digital Cordless for instructions with VM
when PHS phone is set to CFBNA and turn off or out of area.
3. When the PS Out of Area time is shorter than the Call Forward-No Answer time, the caller receives an Out of Area
indication.
4. This Memory Block is used to define the Time a system searches for a PS II before displaying Out of Area or
providing a busy tone to the Caller.
5. When using Call Forward - Busy/No Answer feature, verify that the time is compatible with this Memory Block.
MB1-2-30 = 00 seconds Follows 1-2-22 timer (BNA)
MB1-2-28 PHS off Setting BT Returned to call RBT
Setting RBT Returned to call RBT
MB1-2-28 PHS Busy Setting BT Returned to call RBT
Setting RBT Returned to call RBT
MB1-2-30 = XX seconds Follows 1-2-30 timer
MB1-2-28 PHS off Setting BT Returned to call BT
Setting RBT Returned to call BT
MB1-2-28 PHS Busy Setting BT Returned to call RBT
Setting RBT Returned to call RBT
3 0 : O U T T I M E R = 0 8 s
T I M E D I S P L A Y
Data
No.
Title
Setting Data
Data 00~99
To Next Page
Loading...
