NEC Xen IPK - ACR Max Digit Assignment

290 – Chapter 1 DRAFT 3 ACR Max Digit Assignment, 1-14-07
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-14-07
System Mode
1
Submode
14
Data No.
07
PC Programming
+ AM
ACR Max Digit Assignment
General Description
Use this Memory Block to specify the number of digits to be collected by the system before
the message is sent to the network
.
System Software R2000 or higher is required.
Display
Programming Procedures
1
Go off-line.
2
Press LK1 + LK14 + KG to access the Memory Block.
3
Use dial pad keys to enter Setting Data
.
Note:
Use the following to enter data:
Jto move cursor left.
Lto move cursor right.
K~I to enter data
Default Values
Length = 24 Digits
Valid range for setting data: 01~99
4
PressNto write the data.
5
PressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
3-03 Trunk-to-Trunk Group Assignment
4-40 LCR Class Selection
1-1-30 Route Advance Block Assignment
1-8-08 Class of Service (Station) Feature Selection 2
1-14-00 ACR Allow/Deny Selection
1-14-01 ACR Dialling Assignment
1-14-02 ACR Dial Allow/Deny Selection
1-14-03 ACR Route Table Number Assignment
1-14-04 ACR Trunk Group to Route Number Assignment
1-14-05 ACR Digit Delete Assignment
1-14-06 ACR Digit Add Assignment
N
1. When 00 is set for this Memory Block, refer to Memory Block 1-1-81 (ISDN / K-CCIS Interval Time
Selection) for the time it takes before the message is sent to the K-CCIS Network
.
2.
ARS Max Digit Assignment applies to K-CCIS Trunk Routes routed through Automatic Route Selection.
0 7 : M A X D G T 0 1 = 2 4
T I M E D I S P L A Y
Data
No.
Title
Setting
Data
Route
01~32