NEC Xen IPK - Telephone Mode Copy Assignment

6-4, Telephone Mode Copy Assignment DRAFT 3 Chapter 1 – 497
Xen IPK Programming Manual
Doc. No.: 8194 - Release 2.0 December 2004
6-4
6
Submode
4
Data No.
—
Telephone Mode Copy
Assignment
General Description
Use this Memory Block to enable copying data from one telephone port to another telephone port
or multiple consecutive telephone ports.
Example: To copy data of telephone port 10 to telephone ports 20~30:
1. Enter the original Tel. No. Using the dial pad, press
KK.
2. Press
N.
Display
Programming Procedures
1
Go off-line.
2
Press LK6 + LK4 to access the Memory Block.
3
Enter the Tel. Port No. to be copied.
Note: Use the following to enter data:
K~I to enter numeric data
U to clear all data when placed at cursor position
Related Programming
No related programming is necessary for this Memory Block.
T E L — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
T E L — —
Æ
T I M E D I S P L A Y
Title
Setting
Data
— —
Æ
T E L —
T I M E D I S P L A Y
Setting
Data
Title