NEC Xen IPK - Call Monitoring Alert Assignment

126 – Chapter 1 DRAFT 3 Call Monitoring Alert Assignment, 1-1-86
December 2004 NEC Business Solutions Ltd
Doc. No.: 8194 - Release 2.0 December 2004
1-1-86
System Mode
1
Submode
1
Data No.
86
PC Programming
+ AN
Call Monitoring Alert
Assignment
General Description
Use this Memory Block to specify whether or not Call Monitoring Alert Tone is allowed. When
allowed, the Conference LED indicates Call Monitoring. When denied, the Conference LED does
not indicate Call Monitoring.
System Software R2000 or higher is required.
Display
Settings
LK 1 LK 2 LK 3 LK 4 LK5 LK6 LK7 LK8
The shaded area indicates
the default settings.
YS NO
Programming Procedures
1
Go off-line.
2
Press LK1 + LK1 + HF to access the Memory Block.
3
Press the corresponding CO/PBX line key to change the data option.
4
PressNto write the data and display the next Memory Block.
5
Program the next Memory Block or pressPto go back on-line.
Related Programming
M.B. Number Memory Block Name
1-8-08 Class of Service (Station) Feature Selection 2 (Pg6, LK6 and LK7)
N
1. When YS is assigned, Call Monitoring Tone and the Conference LED indicate Call Monitoring.
2. When NO is assigned, Call Monitoring Tone and the Conference LED do not indicate Call Monitoring.
8 6 : A L E R T T O N E = Y S
T I M E D I S P L A Y
Data
No.
Code
Table
01~10
Setting Data